Sauder Briarbrook Serie Instrucciones De Montaje página 9

Step 3
å
Separate the EXTENSION SLIDES (2) from the EXTENSION RAILS (1) as shown in the upper
diagram below. Be prepared, the parts are greasy.
å
Fasten two EXTENSION RAILS (1) to the UPRIGHTS (D and E). Use six BLACK 1/2" FLAT
HEAD SCREWS (25).
å
NOTE: For each EXTENSION RAIL, turn a SCREW into the 1
diagram. Then, slide the inner cartridge of the EXTENSION RAIL in to find the other holes that
line up with the holes in the UPRIGHT. Turn a SCREW into these holes.
å
NOTE: The EXTENSION SLIDES will be used later for the DRAWERS.
å
Push four HIDDEN CAMS (5) into the UPRIGHTS (D and E).
2
Push the black lever and pull the SLIDE from the RAIL.
Open end
430074
Open end
Arrow
5
1
1 hole
st
E
www.sauder.com/service
hole shown in the enlarged
st
1
Use these holes.
1
1 hole
st
D
BLACK 1/2" FLAT HEAD SCREW
(6 used in this step)
7
1 hole
st
Open end
25
Page 9