Sauder Briarbrook Serie Instrucciones De Montaje página 18

Step 12
å
With someone's help, place your Hutch onto the 430072 making sure the back edges
of the two units are even.
å
NOTE: In this step, you may want to start each SCREW a few turns before completely
tightening any of them.
å
First, fasten the BRACKETS (L) to the BOTTOM SURFACE of the BASE TOP. Tighten
four 9/16" HEX HEAD SCREWS (20) using the L-WRENCH (14).
å
Next, fasten the BRACKETS (L) to the END FRAMES (J). Using the L-WRENCH (14) and
WRENCH (15), tighten four 3/8" HEX HEAD SCREWS (25) through the BRACKETS,
through the END FRAMES (J), and into four NUTS (7).
3/8" HEX HEAD SCREW
(4 used for the END FRAMES)
14
9/16" HEX HEAD SCREW
(4 used for the BASE TOP)
Page 18
25
J
L
20
www.sauder.com/service
J
L
7
15
430073