Sauder Briarbrook Serie Instrucciones De Montaje página 19

Step 13
å
Place your unit in its final location against a wall.
å
The following instructions show your unit being fastened to a wall stud. If you are not
fastening your unit to a wall stud, go to the next step now.
å
1 - Locate the center of a stud in your wall near your unit and mark it with a pencil
st
just below the top surface of your unit so the SAFETY STRAP will not be visible.
å
2 - Drill a 1/8" hole on the mark and into the stud in your wall.
nd
å
3 - Fasten the unit to the wall. Use the LONG SCREW through the other end of the
rd
SAFETY STRAP and into the 1/8" hole.
Mark and drill
a 1/8" hole into
the wall stud.
1
st
96
430073
Electric drill with 1/8" bit
2
nd
3
rd
www.sauder.com/service Page 19