EarthQuaker Devices EQD LEDGES Manual Del Usuario página 7

Helpful expression assignment tips
• If you turn the control that is assigned to the EXP jack
while the expression pedal is plugged in, the panel control
will override the expression pedal setting. The expression
pedal will reassume control the next time it is used.
• Different EXP assignments can be saved in each preset.
• You can use Control Voltage with the EXP jack! The
CV range is 0 to 3.3v.
TRS expression pedal wiring
Tip ...................................... Wiper
Ring ...................................+3.3V
Sleeve ..............................Ground
FLEXI-SWITCH TECHNOLOGY
®
This device features Flexi-Switch Technology! This
relay-based, true bypass switching style allows you to
simultaneously use momentary and latching-style switching.
• For standard latching operation: Tap the footswitch
once to activate the effect and then tap again to bypass.
• For momentary operation: With the effect off, hold the
footswitch down for as long as you'd like to use the effect.
Once you release the switch, the effect will be bypassed.
NOTE: HOLDING THE BYPASS SWITCH DOWN
WHILE LEDGES IS ACTIVATED WILL SWITCH
INTO THE SELECTED PRESET MODE!
Ledges is buffered bypass with tails. Power is required
to pass signal.
POWER REQUIREMENTS
Current Draw .................... 80 mA
This device takes a standard 9 volt DC power supply with
a 2.1mm negative center barrel. We recommend using
a pedal-specific, transformer-isolated, wall-wart power
supply or a power supply with multiple isolated-outputs.
Pedals will make extra noise if there is ripple or unclean
power. Switching-type power supplies, daisy chains and
non-pedal specific power supplies do not always filter
dirty power and may result in unwanted noise.
DO NOT RUN AT HIGHER VOLTAGES!
TECH SPECS
Input Impedance ................ 1 MΩ
Output Impedance .............100 Ω
WARRANTY
This device has a limited lifetime warranty. If it breaks,
we will fix it. Should you encounter any issues, please
visit www.earthquakerdevices.com/support.
7