Lotus ILM6S10 Manual De Instrucciones página 3

Ocultar thumbs

página de 7

/ 7
Marcadores

Idiomas disponibles

ENGLISH

INSTRUCTION MANUAL

A)DISPLAYS AND BUTTONS

Chronograph second

Chronograph minute

Normal second hand

Chronograph 1/20

second hand

Chronograph

minute hand

Normal second hand

B) SETTING THE TIME

1. Pull the crown out to the 2nd Click Position.

2. Turn the crown clockwise to set hour and minute hands.

3. After the time has been set, push the crown back to the Normal position.

C) SETTING THE DATE

1. Pull the crown out to the 1st Click Position.

2. Turn the crown clockwise to set the date.

* If the date is set between the hours of around 9:00 PM and 1:00 AM, the date may not change on the following day.

3. After the date has been set, push the crown back to the Normal position.

D) USING THE CHRONOGRAPH

Este cronógrafo puede medir y mostrar la hora en fracciones de 1/20 segundos hasta un máximo de 59 minutos 59 This

chronograph is able to measure and display time in 1/20 second united up to maximum of 59min 59sec. The chronograph

1/20 second hand keeps continuously for 30 seconds after starting, and then stops at Zero position.

[Measuring time with the stopwatch]

1. Press button " A " to start the chronograph.

2. The chronograph can be started and stopped each time button "A" is pressed.

3. Press button "B" to reset the chronograph and chronograph minute and second hands return to their Zero positions.

E) CHRONOGRAPH RESET (INCL. AFTER REPLACING BATTERY)

This procedure shoud be performed when the chronograph second hand does not return to the Zero position.

1. Pull the crown out to the 2nd Click Position.

2. Press the button "A" once to set the chronograph second hand to the Zero position.

3. Press the button "B" once to set the chronograph 1/20 second hand to the Zero position.

* The chronograph hands can be advanced rapidly by continuously pressing button "A" or "B".

4. Once the hands are set at Zero position, reset the time and return the crown to its normal position.

By virtue of the regulations pursuant to the handling of waste products deriving from electronic and electrical equipment, end of lifecycle watch making

products must be selectively collected for processing. You may therefore dispose of your quartz watch making products at any of our retail outlets or any other

authorized collection point. The selective collection, processing, rating and recycling of these products helps contribute to safeguarding the environment and

protecting our health.

hand

Hour hand

hand

6S10

Reset

ILM6S10/20/30

6S20

Button A

6S30

Time Measurement

Minute hand