Publicidad
Idiomas disponibles
Idiomas disponibles
7. AC adapter
3
Installation
3.1
PLACING THE INDOOR UNIT
(MONITOR)
The indoor unit (monitor) is designed to stand on a table or any flat
surface.
A. Pull out the stand leg on the back of the indoor unit.
B. Pull the antenna on the back of the indoor unit to an upright
position.
C. Place on any flat surface.
3.2
ELECTRICAL INSTALLATION
3.2.1 Connecting AC power to the indoor unit
(monitor)
The monitor is portable and can be used on battery power, AC power
or both. When the AC adapter is connected the battery charges until
full and then operates directly from the AC adapter. The AC adapter
used is a standard micro USB charger.
3.2.2 Installing and charging the indoor unit
battery
A. Open the battery cover on the back of the unit.
B. Check the label on the battery for the correct orientation.
C. Insert the battery and place back the battery cover.
D. Insert the micro USB adapter to charge the battery.
E. Charge the battery completely before using the monitor on battery
power alone.
3.2.3 Installing a MicroSD card (Not included)
To record video, a MicroSD card is required. Photos are stored on
the memory of the monitor itself.
A. Remove the battery cover and the battery of the indoor unit. (see
section "Installing and charging the monitor battery")
B. Open the MicroSD card cradle by sliding it. (see marking on
cradle for direction)
C. Insert the MicroSD card into the cradle with pins facing down.
D. Close the cradle and slide it to the closed position. (see marking
on cradle for direction)
4
Basic functions
4.1
CONTROL BUTTONS
1. Intercom / monitor button
2. Unlock buttons
3. Menu / OK button
4. Up button / photo or recorder button
5. Direction buttons (down, left and right)
6. Call button / pair button
Instruction manual
EN
7
Publicidad
