Ryobi PCL265 Manual Del Operador página 7

NOTICE:
To prevent gear damage, always allow the anvil to come
to a complete stop before changing the direction of
rotation.
WARNING:
Battery tools are always in operating condition. Lock the
switch when not in use or carrying at your side, when in-
stalling or removing the battery pack, and when installing
or removing sockets.
INSTALLING / REMOVING BATTERY PACK
See Figure 3, page 9.
 Lock the switch trigger.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and that battery pack is secured in the
product before beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, see the operator's manu-
als for your battery pack and charger.
INSTALLING AND REMOVING SOCKETS
See Figure 4, page 9.
Use only sockets designed for impact wrenches. Always
select the correct size impact socket for nuts and bolts.
CAUTION:
Using the wrong size socket may damage the nut or
bolt and cause the fastening torque to be inaccurate or
inconsistent.
 Remove the battery pack.
 Push the socket onto the anvil until the friction ring locks
it into place.
 To remove the socket, pull it away from the anvil.
LED LIGHT
See Figure 5, page 9.
The LED light at the base of the tool illuminates when the
switch trigger is depressed.
The LED light illuminates only when there is a charged bat-
tery pack in the tool.
NOTE: MAINTENANCE INSTRUCTIONS BEGIN ON PAGE 8
FOLLOWING FRENCH AND SPANISH LANGUAGE SECTIONS.
OPERATION
ILLUSTRATIONS START ON PAGE 9.
7 - English
OPERATING THE IMPACT WRENCH
See Figures 6 - 7, page 9.
CAUTION:
The metal surface may become hot during use. Avoid
contact with it to avoid possible burn injury.
Proper fastening torque may be determined by the kind of
bolt, the size of the bolt or the material or the workpiece. It
is helpful to perform a test operation to determine the proper
fastening time for the nut or bolt you are using.
 Hold the tool with one hand and pointed straight at the
nut or bolt.
 Depress the switch and fasten for the proper fastening
time.
 Remove the impact wrench from the nut or bolt.
 Check the torque with a torque wrench.
NOTICE:
Do not use this tool to install lug nuts on wheels without
a torque limiting device. Doing so could result in galled
or broken lugs.
IMPACT TIME
Many variables exist that will cause the maximum torque
to the fastener to vary considerably, including the size and
threading of the fastener, lubrication, material hardness, and
environmental conditions.
NOTE: Using a universal joint or extension bar may reduce
the fastening force of the impact wrench and require longer
fastening time.
NOTICE:
After the head of a nut or bolt has seated, additional im-
pacting will increase the chance of shearing bolts, nuts,
sockets or tearing into wood.
ELECTRIC BRAKE
The electric brake will stop the socket rotation after the
operator releases the switch trigger.