Ledvance SMART+ OUTD WIFI FLOOD Instrucciones página 8

HOW TO USE
LIGHT SETTINGS
Time settings
• The time (switch-off delay) can
be set from 5s – 360s
• Every detected movement
re-activates the light
Twilight settings
The brightness response thresh-
old (twilight) can be infinitely
varied from approx. 10 – 500lux
Factory settings
• Time setting: 25s
• Twilight setting: 100lux
AIMING FLOODLIGHT HEAD
The Floodlight head can be adjusted
• Up/down 50°
• Left/right 110°
CAMERA FUNCTION
• The camera films a sequence
when the sensor is triggered
• The filmed sequence is saved
on the memory card or cloud
storage and can be retrieved at
any time
• The recorded data is saved on
the unit's memory card or cloud
storage
• A QR code is generated on the
smartphone or tablet which can
be read by another smartphone
or tablet
• Once the sensor has been
triggered, the user receives
a push notification via the
LEDVANCE App (can be
deactivated)
– Open LEDVANCE App
– Use image display and intercom
system
– Switch between HD and SD
mode possible
– If HD image shows delay,
SD is recommended
8
All functions are selected and used via the LEDVANCE App.
AIMING CAMERA
The camera can be adjusted
(LEDVANCE WIFI APP)
• Up/down 90°
• Left/right 340°
ALARM FUNCTION
– Acoustic alarm signal reacting
on detected movement
FOUR SECURITY MODES
– Sensor sensitivity can be adjust-
ed (low, medium, high)
Low level:
• System default lighting envi-
ronment: 100lux
• Sensor distance: 5m
• Lumen adjustable: 10%-100%
• Lighting time: 25s
Middle level:
• System default lighting envi-
ronment: 100lux
• Sensor distance: 8m
• Lumen adjustable: 10%-100%
• Lighting time: 25s
High level:
• System default lighting envi-
ronment: 100lux
• Sensor distance: 12m
• Lumen adjustable: 10%-100%
• Lighting time: 25s
Further information on the func-
tions and setting options can be
found in the LEDVANCE App.
INSERT SD MEMORY CARD
– Remove cover
– Insert SD memory card
– Fit cover
RESTORING FACTORY
SETTINGS
– Remove cover
– Using the needle, press reset
button for approx. 3s until the
signal sounds
While resetting:
Status LED lights up
Flashes fast
After resetting:
Acoustic signal one time
Status LED flashes
Flashes slowly
– Open LEDVANCE App
– Clear camera in LEDVANCE App
– Re-configure unit
– Fit cover