Publicidad
Idiomas disponibles
Idiomas disponibles
Please consult a qualified electrician, electrical inspector, or
the local agency having jurisdiction:
„ In some areas, products are required to be registered with
local utility companies.
„ If the product is used at a construction site, there may be
additional regulations which must be observed.
CHARGING THE POWER STATION
See Figure 2.
The power station is shipped in a low charge condition.
Therefore, you should charge prior to first use.
„ Connect the charger connector plug to the input jack on
the power station, then plug the charger's AC power cord
into a standard electrical outlet that is nominal 120/60 Hz
AC (typical U.S. household type circuit).
„ The LCD display will show charging condition, time remain-
ing until full charge level, and full charge output.
NOTE: The power station will turn off after the battery
is fully charged. The AC output button must be OFF for
this shutoff to occur.
„ Do not use, store, or charge battery packs or products
in locations where the temperature is less than -4°F
or more than 113°F. Do not store outside or in vehicles.
NOTE: If connecting the charger immediately after using the
power station at a high AC load, the battery temperature
may be outside the acceptable charging range and cause
the LCD display to show an error condition. If this occurs,
charging will begin automatically once the battery temperature
reaches an acceptable level.
USING THE POWER STATION
See Figure 3.
NOTE: The power station is capable of pass-through charg-
ing. When the power station is charging and discharging
simultaneously it is recommended to use only the DC outlets
to charge or power external devices.
ALERT FUNCTIONS
AC Output
Button LED Audible Alert
Beep every
Flashing Red
second
Beep every
Solid Green
5 seconds
Solid Green
Beep every
or OFF
5 seconds
OPERATION
LCD Display
Shows
OVERLOADED
Unit is overloaded.
Blinking battery
icon/percent of
Battery needs charging.
charge remaining
Battery operating or
Blinking battery
charging temperature
icon with LOW
is outside of normal
or HIGH TEMP
Blinking
System fault detected.
system fault
10 — English
To power the product on:
„ Press and hold the main power button for two seconds
to turn the product on. This will activate the LCD display
and allow the USB charging ports and LED task light to
be used.
NOTE: The main power button will illuminate when power
to the unit is on.
„ To use the AC outlets:
„ After powering the product on, press the AC output but-
ton to activate the AC outlets.
NOTE: For normal operation of the power station, the main
power button and the AC output button (if using AC outlets)
will be solid green and there will be one audible beep. If any
other light pattern or beeps occur, refer to the Alert Func-
tions chart that follows.
Sleep mode:
„ After 30 minutes of inactivity, the product will enter into
sleep mode. In this state, the main power button LED will
blink slowly and the LCD screen will turn off. All unit func-
tion is disabled to conserve power, but the Bluetooth
connection will remain active.
NOTE: Sleep mode will not occur if the AC output but-
ton is ON.
„ Press the main power button to end sleep mode.
„ Automatic shut-off:
„ The power station will automatically power off after
12 hours of inactivity. The Bluetooth
disabled at this time.
To manually turn the product off:
„ Press and hold the main power button for two seconds.
WARNING:
While operating, maintain clearance on all sides of this
product. Do not block vents or allow the product to
overheat.
Problem
Remove all loads, press the AC output
button, then add back one load at a time,
being sure not to exceed product rating.
Connect to power outlet to charge.
Allow product to cool or warm to normal
operating temperature as needed.
threshold.
connection is also
®
Solution
Contact customer service.
®
Publicidad
