Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT SPECIFICATIONS
PRODUCT
Power Source .................................................... Li-ion NMC
Cell Capacity .................................... 1094Wh (48V, 22.8Ah)
Rated AC Output ...............120 Volt AC, 60 Hz., 13.3 Amps
Rated DC Output:
USB-A ...................................... 5 Volts, up to 2.1 Amps
USB-C ...............................5/12/20 Volts, up to 3 Amps
KNOW YOUR PRODUCT
See Figure 1.
The safe use of this product requires an understanding of the
information on the product and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
120 V AC RECEPTACLES
Your product has three single phase, 60 Hz outlets that are
120 Volt AC, 15 Amp receptacles. These can be used for
operating appropriate appliances, electrical lighting, tools,
and motor loads.
AC OUTPUT BUTTON
The AC output button is used to activate the 120V AC outlets
when the power station is on. If an overload occurs, remove
all loads, then press the AC output button again to reset.
CARRY HANDLE
The product is equipped with a folding carry handle for easy
transport. The handle should be used to carry the product.
CHARGER
Using the charger before storing the power station helps keep
the power station's battery charged and ready at all times.
GENCONTROL
WITH BLUETOOTH
™
The GENCONTROL
monitoring system with Bluetooth
™
tracks battery level, runtime, load, and other functions.
FEATURES
(15.0 Amps for 3 min. Max)
®
8 — English
Rated Output ..................1,600 W (1,800 W for 3 min. Max)
Starting Watts ......................................................... 3,000 W
Charger Input.. nominal 120V/60Hz AC only, up to 5 Amps
Charger Output .............................54.6 VDC, up to 5 Amps
LED TASK LIGHT
The LED task light can be used to provide general illumina-
tion for most work spaces.
MAIN POWER BUTTON
The main power button is used to turn the power station
on and off. When turned on, power is available at the USB
ports and to the LCD screen and LED task light. To use the
AC outlets, the AC output button must also be turned on.
PARALLEL KIT TERMINALS
The non-polarized parallel kit terminals are used with a
parallel kit that will allow products to be linked together to
increase output.
NOTICE:
Connect the cables before turning the product on. Do
not disconnect cables while the product is running. The
product or the load may be damaged.
NOTE: Read and understand the parallel kit's instructions
prior to use. Battery-powered inverters will not have a ground
terminal; the ground wire will not be needed and can be left
unconnected.
USB PORTS
This product has four USB-A (5V, 2.1A) and two USB-C
(5/12/20V, 3A) charging ports that will charge most USB-
®
compatible devices.
Publicidad
