Publicidad
When the signal disappears the radio will automatically switch again to FM radio mode.
6.9 Flashlight
This func�on is very useful for night illumina�on.
To turn it on press [Monitor/Lamp]; push it again, the flash light will be strobe; push it again: it will turn off.
6.10 1000Hz, 1450Hz, 1750Hz Tone-burst
To send out a tone-burst (selectable by MENU 41); press the [FM] key while holding down the [PTT].
A common tone burst frequency used by many amateur radio systems in Europe is 1750 Hz.
you can select from 2100, 1750,1450, or 1000Hz Tone Burst Op�ons. These op�ons are found on the Menu 41(R-TONE).
6.11 Manual Programming (Channels Memory)
Memory channels are an easy way to store commonly used frequencies so that they can easily be retrieved at a later date.
The BAOFENG EU9X EU features 128 memory channels that each can hold: Receive and transmit frequencies, transmit power,
group signaling informa�on, bandwidth, ANI/ PTT-ID se�ngs and a six-character alphanumeric iden�fier or channel name
Frequency Mode vs. Channel Mode
Switch between modes by using holding the [MUNU] bu�on during a power cycle of the EU9X EU (volume knob off/on).
These two modes have different func�ons and are o�en confused.
Frequency Mode (VFO): Used for a temporary frequency assignment, such as a test frequency or quick field programming if
permi�ed.
Channel Mode (MR): Used for selec�ng preprogrammed channels.
Ex 1. Programming a Channel Repeater Offset with CTCSS Tone
EXAMPLE New memory in Channel 10:
RX = 432.000 MHz
TX = 437.000 MHz (This is a (+ 5) Offset)
TX CTCSS tone 123.0
a. Change from Menu to Menu by pressing the [EXIT] key.
b. Turn off the radio, then press and hold the [MENU] key to turn on the radio and set it to VFO mode.
18
1
.
Publicidad
