LG WT15DSBP Manual Del Propietário página 15

Connecting Hose to Appliance
Attach the hot water line to the hot water inlet
on the back of the washing machine. Attach the
cold water line to the cold water inlet on the
back of the washing machine.
NOTE
• After completing connection, if water leaks
from the hose, repeat the same steps. Use
the most conventional type of tap for the water
supply. In case the tap is square or too big,
remove the guide plate before inserting the
tap into the adaptor.
Installing the Drain Hose
Before connecting the drain hose, check your
drain hose model and choose the correct
instruction.
Pump Model
• The drain hose should not be placed higher
than 120 cm above the floor. Water in the
washing machine may not drain or may drain
slowly.
• Securing the drain hose correctly will protect
the floor from damage due to water leakage.
• If the drain hose is too long, do not force it
back into the washing machine. This will
cause abnormal noise.
• When installing the drain hose to a sink,
secure it tightly with string.
Laundry tub
NOTE
• The discharge height should be approximately
0.9 - 1.2 m from the floor.
Hose
retainer
Tie strap
EN
15