Publicidad
Idiomas disponibles
Idiomas disponibles
6
7
3
1
2
4
Tighten the safety wire clamp. Place ring of safety wire through the expansion
bolt or self tapping screw and fix it to the building structure.
9
Hanger Ball
(Green/Yellow)
AC IN L(Black)
AC IN N(White)
Controller
(Receiver)
MOTOR U
MOTOR V
MOTOR W
LIGHT N
LIGHT L
FROM POWER SOURCE AC 110-120VOLT 60Hz 3.5AMPS.
Connect wires from controller to power supply with wire connectors.
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER
Mounting Bracket
Earth
Live
Neutral
Antenna
Fan
Plug
Light
Installation & Operating Instructions for the
Parrotuncle Owner's Installation ,Manual
Raise the fan and place the hanger ball onto mounting
bracket. Rotate the fan until the notch on hanger ball
snapped into the slot on mounting bracket and sits firmly.
IMPORTANT : THE DOWNROD AND HANGER
BALL SHOULD NOT ROTATE IF THIS STEP IS
DONECORRECTLY.
8
Connect the wire connector plugs correctly. The wire
connector plugs design with fool proof device, please don't
force to plug. Otherwise it may affect the normal use of the
light fan or burn the fan motor.
10
1
Insert the controller into the mounting bracket, and tidy up the
wiring. Push the canopy to the mounting bracket, make two
sliding holes aligned to the two prominent screws on the
mounting bracket, and then turn clockwise until tight. Push the
canopy ring to the canopy.
A570801CA
2
3
4
Publicidad
