Publicidad
Idiomas disponibles
Idiomas disponibles
4. OPERATION
Connecting the water supply
This unit is to be used with a cold-water
source only!
The pressure washer must only be used
with clean water; use of unfiltered water
or corrosive chemicals will damage the
pressure washer.
Ensure that you have a suitable water
supply to feed the pressure washer.
Check that all connections are tight and
there are no leaks in the hose.
You can enable the water supply via a water tank
(or pond, rain barrel, etc.) or via a water tap.
Water tank (water suction function)
Fig. 5A
Clean the suction filter (9) at regular
intervals, and check it for damage.
Otherwise, its function can be impaired.
When water is supplied via a water tank, pond,
rain barrel, etc. , the assembled suction hose (7)
must be used. Only clear fresh water may be used.
1. Connect the assembled suction hose (7) to the
pressure washer, place the hose connector (5)
on to the water inlet (4).
2. Lower the suction filter (9) into water. Ensure
there are no obstructions around the suction
filter (9). Move the float ball (8) in such a way
that the suction filter (9) does not touch the
water bottom. The suction filter (9) must be
placed at least 20 cm from the water bottom to
prevent the suction of sand.
3. Check that the hose has no kinks in it.
4. The pressure washer is now ready for use.
Water tap
Fig. 5B
Use the device on a domestic water
connection with maximum pressure of
5 bar.
The supply tap should be fully open.
1. Ensure that you have a suitable water supply
to feed the pressure washer.
8
2. Connect the water supply hose (not included)
to the water inlet (4).
3. Connect the water supply hose (not included)
to the water supply.
4. Turn on water and heck that the hose has no
kinks in it.
5. The pressure washer is now ready for use.
Switching the pressure washer on/off
Fig. 1
The motor of this pressure washer will
NOT run. It will only operate when the
trigger is squeezed.
Before starting make sure the pressure
washer is connected to a water source.
Dry running will damage the pressure
washer!
• To start the pressure washer, press and hold
the release button (11) and press the switch
lever (10).
• To stop the pressure washer, release the
switch lever (10).
Adjusting the nozzle (3)
Fig. 6
Water may be sprayed out of the nozzle (3) either
linearly or in a fan shape. Turn on the pressure
first, and then adjust the nozzle (3).
Finish operation
Fig. 1
1. After use (when water is supplied via a water
tank, pond, rain barrel, etc.) allow the
pressure washer to run using clean water for
2 - 3 minutes in order to remove residues and
particles that may have accumulated in the
machine and hose. This is not necessary when
used with clean tap water.
2. To stop the pressure washer, release the
switch lever (10).
3. Turn off the water supply.
4. Remove the battery from the machine.
5. Press and hold the release button (11) and
press the switch lever (10) to depressurize and
drain the system.
6. Disconnect the hose from the pressure washer.
7. Wipe all surfaces of the unit and accessories
with a damp clean cloth.
Publicidad
