iRobot Roomba j9 Manual Del Usuario página 8

Charging
EN
CLEAN
• Place the robot on the charging station to activate the battery.
Note: Your robot comes with a partial charge, but we recommend that
you charge the robot for 3 hours prior to starting the first cleaning job.
• The robot uses a small amount of power whenever it is on the charging station.
You can put the robot in a further-reduced power state when not in use. To put
your robot into reduced power standby mode, remove the dust bin and tap the
clean button 5 times. To exit reduced power standby mode, place your robot
on the charging station and tap the clean button. For more details on this
Reduced Power Standby Mode, refer to the FAQ page on our website.
• For long-term storage, turn off the robot by removing it from the charging
station and holding down the clean button for 3 seconds with one wheel off
the ground. Store the robot in a cool, dry place.
4 For more information, visit global.irobot.com
Light Ring Spiral While Charging
White Spiral: charging
Red Spiral: charging, low battery
A solid white light will indicate the battery charge
percentage of your robot
When your robot is fully charged, the light ring
indicator will intermittently pulse white at the rear.
Cleaning
Just press the clean button
Tap to Start/Pause/Resume
Hold for 2-5 seconds to end a job
• Your robot will automatically explore and clean your home. It will return to
the charging station at the end of a cleaning job and whenever it needs to
recharge.
Remove excess clutter from floors before cleaning. Use your
robot frequently to maintain well-conditioned floors.
• To end a job and send the robot back to its charging station, hold the clean
button down for 2-5 seconds. A blue light ring pattern will indicate that the
robot is seeking the charging station.
• When your robot detects an especially dirty area, it will engage Dirt Detect™
mode, moving in a forward/backward motion to clean the area more
thoroughly. The light ring indicator will flash blue.
When the robot senses its bin needs to be
emptied, the light ring indicator will illuminate
in a red sweeping motion toward the rear.