Senix PDDX2-M2 Manual De Instrucciones página 12

CHARGING INDICATOR
Press the light button on the battery pack to
check whether it needs to charge.
Light Button Indicator
Lights
Fully Lit Blinking
WARNING:
Malfunctions may occur when the four lights
blinking in turns.
OVERHEAT PROTECTION
When the tool/battery is overheated, the tool
stops automatically. In this situation, let the
power tool/battery cool before turning the tool
EN - 12
on again.
OVERDISCHARGE
PROTECTION
When the battery capacity is not enough, the
tool stops automatically. In this case, remove
the battery from the tool and charge the
battery.
WORK AREA SET UP
1. Designate a work area that is clean and well
2. Secure loose workpieces using a vise
3. There must not be objects, such as utility
Status
PRACTICAL ADVICE
75% - 100% 1.
a.
50% - 75%
b.
25% - 50%
c.
d.
5% - 25%
< 5%
(needs to be
e.
charged)
f.
lit. The work area must not allow access by
children or pets to prevent distraction and
injury.
or clamps (not included) to prevent
movement while working.
lines,nearby that will present a hazard while
working.
General
Ensure the tool is fitted with a suitable bit
for current work and the direction selector
is at center lock position before start.
Always keep the product perpendicular to
the work area. Otherwise, bit is more likely
to slip or be jammed and cause damage to
the tool.
Place the power tool in a start position first
and then switch the product on.
The feeding force and running speed
depends on tool characteristics and the
work material. Excessive feeding force
will overload the power tool and increase
the risk of losing control. Ask a power tool
specialist for advice if necessary.
If the tool gets stuck in work area, switch
off and try to perpendicularly draw it
out with slight force to avoid damage. If
this does not work, switch to backward
mode, run the tool at a slow speed and
perpendicularly draw out with slight force.
Check the power tool and its clamping
status regularly during work. Refit or
replace it if necessary.
WWW.SENIXTOOLS.COM