DROP Escape Modo De Empleo página 9

CLEANING
We recommend that you clean the Escape Ultrasonic Dif-
fuser every time you switch from one essential oil combi-
nation to another or when you have not used the device for
some time. Essential oils are corrosive and after a time can
accumulate on the ceramic elements. Follow these simple
cleaning and maintenance instructions to ensure the long
life of your diffuser:
- Turn off the device and remove the plug from the electricity
socket. Remove the cover and pour away any remaining
water.
- Rinse the water reservoir thoroughly and dry it with a clean
cloth. Do this every time you use a new essential oil.
- Use a moist cloth to clean the outside of the device.
- Make use the water does not get into the ventilator.
- Use a cotton bud and a few drops of alcohol to clean the
ultrasonic plate.
- Do not use detergents, solvents or abrasive products to
clean the device.
- Place the diffuser on a dry and level surface.
The manufacturer cannot be held liable for damage
caused by incorrect cleaning and/or use of the
Escape Ultrasonic Diffuser.
TECHNICAL DETAILS
Dimensions: approx. 71 x 71 x 140 mm
Weight (without adaptor): +/- 150 g
Colour: black or white
Characteristics:
Noise level: very quiet - Continuous and intermittent modes -
Breathing light - Portable and ideal for travel - Automatic
deactivation function
Capacity: 5 W max.
Adaptor power: DC 5V / 1A
Capacity water reservoir: 55 ml
Vapour discharge: approx. 18 ml/hour in continuous mode
and 9 ml/hour in intermittent mode
Accessories: 1 USB cable, 1 instruction manual
Recommended area of use: 10-30 m²
16
SAFETY PRECAUTIONS
Follow the recommended measures below to avoid
defects to your diffuser:
1. Clean the device every time you switch from one essential oil combination
to another.
2. Do not use detergents, solvents or abrasive products to clean the device.
3. Only use clean water at room temperature to fill the water reservoir. Never
use boiling or very cold water.
4. Do not move the device once it is filled with water.
5. Use the adapter provided by the manufacturer.
6. If you do not use the device for some length of time, remove the plug from
the electricity socket and pour away any water in the reservoir.
7. Never touch the water level sensor and keep the device out of contact with
other objects.
8. Never hold your hand above the ultrasonic plate when the device is turned
on. It can be painful for your hand, as well as damaging for the device.
9. Never wrap the adaptor in paper, plastic or any other similar material, since
this will prevent the adapter from optimally dispersing its heat, which may
lead to warping and/or the burning of the membrane as the result. Never
touch the adapter with wet hands.
10. Never use any other fluids than water and a few drops of essential oil(s).
11. Never direct the vapour at walls, ceilings or furniture surfaces, because the
resulting condensation could cause damage.
12. Do not attempt to disassemble the device.
13. Never place the device on a loose piece of textile, because this might block
the flow of air and prevent the device from diffusing vapour effectively.
14. Treat the diffuser with care, in view of the delicate nature of its surface.
15. Do not tilt, move, empty or fill the diffuser while it is turned on.
17