Getting Started; First Setup; Wheels; Handlebar Height - Mima xari Manual Del Usuario

2 + 3
6
4
3
2
1
7

GETTING STARTED

FIRST SETUP

1. Unfolding the chassis
Push the folding latch sideways to unlock the handlebar.
Pull up the handlebar while holding down the tip of the
chassis with your foot. Continue to pull the handlebar
1 1
towards you until the chassis completely unfolds.

WHEELS

• Please note the L/R indication on the chassis and on
each wheel.
2. Attach rear wheels
Press in the wheel axle hub and insert the axle into the
wheel fitting. Check if the wheels are properly attached by
attempting to pull them out again.
3. Remove rear wheels
4 + 5
Press in the wheel axle hub and pull the wheel off.
4. Attach front wheels
Insert the wheel rod into the wheel fitting and push it in
until it clicks.
5. Front wheel swivel lock
Use the front wheel swivel lock when you are using
on rough terrain.
Push the swivel lock button down to activate. Pull it up
again to deactivate it.
6. Remove front wheels
Slide the unlock button sideways and pull out the front
wheel.

HANDLEBAR HEIGHT

7. Adjust handlebar height
Press and hold both buttons located on the outside of
the handlebar and rotate the handlebar to the desired
position.
EN
xari
7