Publicidad
Idiomas disponibles
Idiomas disponibles
PAG 10
CAUTIONS.
- Be careful that receiver and reemitter leds are correctly pointed without intermediate obstacles (see fig1-A and fig2-B).
- Although you can use any number of receivers and reemitter everywhere, be careful that the walls or domestic objects
always stop the optical coupling between them. So avoid that the same remote control can operate simultaneously with
two receivers (fig4a), that any reemitter can operate with any receiver (fig4b) or that two reemitters can operate at the
same time with the same equipment (fig4c).
- At any point of the installation there is not an amplifier.
- In case of doubt or persistence of any problem consult your distributor.
fig. 4A
TROUBLE SHOOTING CARE AND MAINTENANCE.
If you have some difficulties, consult the following table.
It will guide you though the most common problems and their solutions.
PROBLEM
Reemitter Led does not work
No picture and sound
Remote controls do not work
SPECIFICATIONS.
SPECIFICATIONS REEMITTER
VHF/UHF-Attenuation
Infrared freq input
Modulation level
Size
Weight
SPECIFICATIONS RECEIVER
VHF/UHF-Attenuation:
Input
Minimum level
Infrared output
Size
Weight
fig. 4B
POSSIBLE SOLUTIONS
- Check power supplies
- Adjust controlling Level
- Check TV Bypass connections
- Check power supplies
Be careful that receiver and reemitter leds are orrectly pointed without intermediate
obstacles. At any point of the installation there are some amplifiers.
0.5dB
35~41kHz
0 dBm(0~0dB adj.)
70x38x23.5mm
120g
0.5dB
11MHz-ASK
<50dBµV
37±1kHz
70x38x23.5mm
130g
fig. 4C
All specifications are subject to change.
Publicidad
