nimo electronic ACTV018 Manual De Instrucciones página 9

PAG 9
SETTING UP.
Make the assembly of the fig2 locating the REEMITTER on the TV-socket next to the equipments to be controlled (room1)
and the RECEIVER on the TV-socket of the remote TV-set (room2). Receiver led "B" doesn,t receive directly the emissions
of reemitter led "A" and Remote controls operate normally after connecting ACTV005 power supplies (see fig. 2-C).
Optimize now the situation of the "B" Led (fig. 2) for a correct Operation of the remote controls "D" on the equipment to
be controlled "E".
fig. 2
Note: It is convenient to begin this operation with the RECEIVER level to maximum (fig. 2-G), minimizing later to an opera-
tive level without saturations and interferences.
In order to receive the equipment signal from all the TV-sets, you must have the equipment connected to the head of the
installation as in fig. 2-E or in figs 3A, 3B or 3C. We recommend you the use of DIGI-SENDER/AV SENDER fig. 3C so as to
carry out the function.
fig. 3A fig. 3B fig. 3C