PNI SafeHouse HS007 Manual De Usuario página 5

PAIRING SIREN WIRELESS TO A COMPATIBLE ALARM
SYSTEM LIKE PNI SAFEHOUSE HS550, PNI SAFEHOUSE
HS650, PNI SAFEHOUSE HS600
In the state of arming or disarming, press and hold the setting button of
the siren, until it emits 1 sound and flashes brightly once. Release the
setting button. The siren flashes continuously at this moment, waiting
for the coded wireless signal from the alarm system. From the alarm
system, transmit the pairing signal for the wireless siren. The siren will
emit two long and one short sounds, once it receives the signal, which
means that the pairing has succeeded..
Operation method: press and hold the [set] key until the siren beeps and
the indicator light flashes once.
a. Delete all remote controls and sensors from the siren
Deleting remote controls and sensors from the siren (reset): You can
delete all accessories paired to the siren, if necessary. In this situation,
the siren can no longer work independently with the paired accessories.
In the state of arming or disarming, press the [set] key and keep it
pressed until the siren sounds 4 times and the indicator light flashes
4 times. Release the set key. If you hear 2 sounds, it means that the
deletion is successful.
Operation methods: press and hold the [set] key until the siren sounds 4
times and the indicator flashes 4 times.
b. Independent mode of operation - alarm
Factory status: After powering up and starting (with the anti-sabotage
flap pressed), the siren will emit a flashing light signal - it confirms that it
is ready for configuration.
Armed State: When the siren is in this state, all paired accessories can
trigger an alarm - the red LED rarely flashes intermittently.
Disarmed State: When the siren is in this state, only the parts in the
emergency area (the red LED does not flash) could trigger an alarm, and
all other accessories cannot trigger an alarm.
5 User manual