Vivanco 23411 Instrucciones De Uso página 39

23411
Card Specifications
IEEE 802.3 standards:
Wiring Connector:
Bus Characteristics:
I/O address:
IRQ Line:
Dimensions:
Emission Compliance:
Immunity Compliance:
Power Consumption:
Operating Temperature:
Operating Humidity:
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
NOTE
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio / TV technician for help.
This Class B digital apparatus meets all requirements of the
Canadian Interference-Causing Equipment Regulations.
10BASE-T and 100BASE-TX
RJ-45
32 bits bus master;
PCI local bus revision 2.0
Assigned by the BIOS to a free
I/O address block
INTA; assigned by the BIOS
to a free IRQ (interrupt) number
120mm x 45mm
FCC Part 15 Class B
EN 55022 Class B
CJSPR 22 Class B
IEC 801-2
(Electrostatic Discharge)
IEC 801-3
(Radiated Immunity)
IEC 801-4
(Electrical Fast Transient/Burst)
300mA, 5V
0 to 55 degrees Centigrade
10% to 90%, non-condensing
FCC Compliance Statement
39
PCI Fast Ethernet Card