Publicidad
Idiomas disponibles
Idiomas disponibles
STEAM IRONING
1. Plug power cord into a convenient electrical outlet.
2. Turn Temperature Control Dial clockwise to at least 320°F
(160°C). Lower temperature settings may cause water to drip
out of unit. Heating Indicator Light will illuminate.
3. When Heating Indicator Light turns off, unit is ready to Steam.
4. Pump Steam Button to release burst of steam. When first using,
the Steam Button may need to be pressed several times for the
pump to prime and steam to start.
NOTE: Steam can be emitted from unit in the vertical position.
Once all ironing tasks are finished, immediately turn Temperature
Control Dial counter-clockwise until it is set to Off position. Prop
unit upright on Stands to cool, and refer to CARE & STORAGE
GUIDELINES on Page 12 for proper cleaning and storage.
10 | ENGLISH
Storage & Care
CLEANING & STORAGE
1. Turn Temperature Control Dial to Off position. Unplug power
cord.
2. Prop unit upright on Stands and allow Ironing Plate to cool for
30 minutes.
3. Open Water Tank Cap and drain any remaining water into a
sink or tub. Close Cap when finished.
4. Wipe Main Body and Ironing Plate with a soft cloth lightly
moistened with water.
• DO NOT clean Ironing Plate with detergents or descalers.
• DO NOT clean Ironing Plate with abrasive or
corrosive products.
• DO NOT submerge unit or hold unit under running water.
5. Store in a cool, dry location.
MINERAL BUILD-UP
1. Follow STEPS 1-3 under CLEANING & STORAGE section above;
however, leave Water Tank Cap open.
2. Make a mixture of 0.5 oz. distilled water and 0.5 oz. vinegar.
3. Using included Measuring Cup, pour water-vinegar solution into
Water Tank. Close Water Tank Cap.
4. Follow normal steam ironing procedure, as outlined on Page
ENGLISH | 11
Publicidad
