Publicidad
Idiomas disponibles
Idiomas disponibles
7 ADDITIONAL SAFETY INSTRUCTIONS FOR LASERS
Leaser beam warning
LASER RADIATION
DO NOT STARE INTO BEAM
Class 2 Laser Product
P<1mW 650nm
EN60825-1:2007
Laser beam characteristics
•
WARNING! The laser beam may potentially cause severe eye damage. Never look or
stare directly into the laser beam.
•
During use, do not point the laser beam at people, directly or indirectly through reflecting
surfaces.
•
This laser complies with class 2 according to EN 60825-1:2007. The unit includes no us-
er-serviceable components. Do not open the housing for any reason. If the unit is damaged,
have the damage repaired by an authorised repair agent.
8 ADJUSTMENTS
8.1 Replacing the saw blade (Fig. 1)
Only use sharp and undamaged saw blades. Cracked or bent saw blades must be replaced
immediately.
•
Place this circular saw on its side on a flat surface. We advise that you lower the base plate
(10) as if making a minimum-depth cut; this makes the operation easier.
•
Push the spindle lock button towards the motor housing as the arrow shows in Fig. 1 and
hold it firmly.
•
Turn the blade clamp bolt anti-clockwise by using the spanner supplied with the tool.
•
Remove the blade clamp bolt and outer flange.
•
Raise the lower guard (16) by using the lever for the lower guard (17), and then remove the
saw blade.
•
Clean the saw blade flanges, then mount the new saw blade onto the output spindle and
against the inner flange.
•
Make sure the saw teeth and the arrow on the blade are facing the same direction as the
arrow on the lower guard.
•
Reinstall the outer flange, and tighten the blade clamp bolt.
•
Make sure that the saw blade runs freely by turning the blade by hand.
Before replacing the saw blade, always unplug the tool.
8.2 Adjusting the depth of cut (Fig. 2)
The depth of cut is infinitely adjustable. A clean cut is achieved with the saw blade protruding
from the material by approx. 3 mm.
•
Loosen the adjusting screw for depth adjustment (5).
•
Hold the base plate (10) flat against the edge of the workpiece and lift the body of the saw
until the blade is at the right depth determined by the depth gauge (4) (align the scale line).
•
Tighten the adjusting screw for depth adjustment.
8.3 Setting the mitre angle (Fig. 3)
The mitre angle is infinitely variable between 0° and 45°.
34
Publicidad
