Publicidad
Idiomas disponibles
Idiomas disponibles
•
Loosen the lock lever for angle adjustment (9).
•
Adjust the base plate to the desired angle between 0° to 45°. [See Scale for mitre angle (8)].
•
Tighten the lock lever for angle adjustment.
8.4 Mounting the guide bar (Fig. 4)
Loosen the adjusting screw of the guide bar (11).
•
Slide the guide bar (12) through the slots in the base plate to the desired width.
•
Tighten the adjusting screw to secure it in the position.
•
Ensure that the guide bar rests against the wood along its entire length to give consistent
parallel cuts.
9 OPERATION
9.1 Instructions for use
•
Clamp the workpiece. Make sure that the side which will be visible later is facing down,
because the cut is most accurate at that side.
•
Switch on the machine before it touches the workpiece. Do not exert pressure on the saw
blade. Allow the machine enough time to cut the workpiece.
•
Hold the machine with both hands using both grips. This ensures optimal control over the
machine.
•
For straight cuts along a drawn line, use the marking for straight cuts.
•
For bevel cuts along a drawn line, use the marking for bevel cuts.
9.2 Switching on and off (fig. 5)
•
To switch the tool on, keep the lock-off button (2) depressed and press the on/off switch (1).
•
To switch the tool off, release the on/off switch.
9.3 Dust extraction
A vacuum cleaner can be connected to the dust extraction outlet, either directly to the connec-
tor or using an adapter.
•
If necessary, connect an adapter to the extraction outlet.
9.4 Laser beam
The laser beam is used for projection of the cut on the workpiece.
Switch the laser (14) on by means of the laser on/off switch (13). If you press again the LED
light works and if you press a 3rd time, the LED light as well as the laser will work.
•
Place the machine on the workpiece with the saw marking above the start of the cutting
line.
•
Check that the laser line aligns with the cutting line as marked on the workpiece.
•
Switch on the machine.
•
Follow the "instructions for use" to perform a cut.
•
After use, switch off the laser.
10. CLEANING AND MAINTENANCE
ATTENTION! Before performing any work on the equipment, pull out the power plug.
10.1 Cleaning
•
Keep the ventilation slots of the machine clean to prevent overheating of the engine.
•
Regularly clean the machine housing with a soft cloth, preferably after each use.
•
Keep the ventilation slots free from dust and dirt.
35
Publicidad
