Marmitek WHE-1 Modo De Empleo página 16

Audio
Supported audio
Infrared return function
Frequency range
Environment
Ambient temperature
Humidity
Power supply
External power adapter
Specifications may change without prior notice.
7 Frequently asked questions (FAQs)
Tip: Testing over a long distance is difficult. First, place the HD transmitter and the HD
receiver in the same room (minimum 2 metres apart) to test if everything works and
only then place the HD receiver in another room.
No (or poor) image and sound on TV or projector
• Ensure that the ON/OFF switches at the back of the transmitter and receiver are
in the ''ON'' position.
• Ensure that all HDMI cables are connected properly or replace them.
• Ensure that all 3 LEDs on both the HD transmitter and the HD receiver are lit.
• Ensure that the HDMI source is turned ON and the correct HDMI input is selected
on the TV.
• Ensure that the HDMI source is set to a correct video resolution
(480p, 576p, 720p, 1080i or 1080p). If necessary, consult the user manual of your
HDMI source.
• Disconnect the power adapters from the wall socket and reconnect them to reboot
the Marmitek WHE-1.
No or bad connection between the HD transmitter and HD receiver
• Move the HD transmitter and/or the HD receiver from the immediate vicinity
of the connected HDMI sources and Wi-Fi equipment. These may affect the
range.
• Slightly adjusting the position of the HD transmitter and/or HD receiver may
already help out.
• Too much distance between HD transmitter and HD receiver. Try using shorter
distances.
• Disconnect the power adapters from the wall socket and reconnect them to reboot
the Marmitek WHE-1.
16
2CH PCM stereo
30 ~ 60kHz
0 ~ 40° C
20% ~ 90%
100-240VAC @50-60Hz, 5VDC @ 2A
© MARMITEK