Bose Professional DesignMax DM8C Guia De Instalacion página 6

Installation
Preparing Hard Ceiling (Existing Construction)
Cutting the Ceiling
1. Use the template to trace a hole onto the
ceiling.
2. Cut a hole into the ceiling.
Installing the Tile Bridge
1. Insert the tile bridge rails and ring through
the hole and place the rails parallel to each
other across the ceiling grid or ceiling
furring.
2. Assemble the tile bridge.
Mounting the Loudspeaker
1. Pass the audio wire through the wire opening.
2. Insert the loudspeaker through the hole and into the tile bridge. Make sure the anchors engage on the tile bridge before loosening
your grip on the loudspeaker.
Remove the connector, wire the connector, and reinsert the connector into the loudspeaker. For wiring information, see Wiring the
3.
Loudspeaker on page 4.
4. Tighten the anchor arm screws to secure the loudspeaker. If using a power drill, set to a low torque setting.
WARNING: Over-tightening the screws may result in damage to the anchor attachment point or the ceiling, which could lead
to a falling hazard.
q
e
6 • English
q
q
w
r
BoseProfessional.com
w
w
DesignMax DM8C • Installation Guide