DAILY USE
.
SELECT A FUNCTION
Simply press the button for the function you require to
select it.
.
SET THE LENGTH
After selecting the function you require,
use
or
run.
The time can be changed during cooking by pressing
or
or by increasing the length for 30 seconds each
time by pressing
.
.
SET THE POWER OF THE MICROWAVE
Press
select the power level for the
microwave.
Please note: You can also change this setting during cooking
by pressing
.
.
JET DEFROST
Press
weight of the food. During defrosting,
the function will pause briefly to allow
you to turn the food. Once the operation is complete,
close the door and press
.
ACTIVATE THE FUNCTION
Once you have applied the settings you require, press
to activate the function.
Every time the
button is pressed again, the cooking
time will be increased by a further 30 seconds.
You can press
at any time to stop the function that
is currently active.
. JET START
When the oven is switched off, press
cooking with the microwave function set at full power
(750 W) for 30 seconds.
to set the length for it to
as many times as required to
, then use
or
to set the
.
to activate
. PAUSE
To pause an active function, for example to stir or turn
the food, simply open the door.
The setting will be maintained for 10 minutes.
To start it up again, close the door and press
A beep will signal once ot twice a minute for 10 minutes
when the cooking is finished. Press the STOP button or
open the door to cancel the signal.
Please note: The oven will only hold the setting for 60
seconds if the door is opened and then closed after the
cooking is finished.
.COOLING DOWN
When a function is finished, the oven may carry out a
cooling procedure the oven switches off automatically.
. SAFETY LOCK
This function is automatically activated
to prevent the oven from being
switched on accidentally. Open and
close the door, then press
.
SET THE TIME OF THE DAY
Press
hour (on the left) starting flashing.
Use
and press
to confirm: The minutes will flash on the
display. Use
or
to set the minutes and press
confirm.
Please note: You may need to set the time again following
lengthy power outages.
. MINUTEMINDER
The display can be used as a timer. To activate the
function and set the length of time you require, use
or
. Press
to set the power to 0 W, then press
activate the countdown.
Please note: The timer does not activate any of the cooking
cycles. To stop the timer at any time, press
to start the function.
until the two digits for the
or
to set the correct hour
.
.
to
to
3