Operating Instructions
1
3
Not suited for use in barns!
Connection to
a.) Installation
The fastening hole (5) is used for wall mounting. The appliance must be mounted against a
perpendicular, fireproof wall with the power cable at the bottom, see above figure. For outside
installation the device must also be protected against exposure to rain and direct sunlight.
b.) Functional description of the appliance
Put the appliance into service without fence and earth. If the indicator light (1) flashes at the pulse
rate, the appliance is ready for use.
If the indicator light (1) does not flash, check the supply voltage and/or the power cable. If no fault is
found, the appliance should be checked by a technician.
c.) Functional description with connected fence system ( fence + earth )
The indicator light (1) is only intended as a functional check, it reacts neither to faults in the fence
system nor to a fence power failure. Regular checking of the fence voltage with a commercial
measuring instrument is vital.
If the indicator light flashes faster than once per second, the appliance must be disconnected at once
and checked by a technician before it can be used again.
This equipment carries a 3-year warranty in accordance with our Warranty Terms &
Conditions!
Please see the attached Operating Instructions for safety tips, earthing, commissioning,
warranty terms and conditions and potential sources of fault!
SERVICE Addresses:
Please contact your specialist dealer
2
4
230 V
~!
5
3
-EN-
Indicator light
(flashes to indicate that
1
the appliance is ready
for use)
2 230V ~ power cable
3 Earth connection
4 Fence connection
5 Fastening hole
Version : 2012.1