cecotec TOAST&TASTE DOUBLE W Manual De Instrucciones página 36

ENGLISH
- Plug the toaster into an appropriate wall outlet. The plug must be easily accessible to
disconnect it quickly in case of an emergency.
- Clean the toaster (read the "Cleaning and maintenance" section). Run the toaster at
maximum intensity level for at least 2 minutes.
Please note
- You may notice a slight burning smell or smoke when using the toaster for the first
time, caused by the excess of lubricants from the manufacturing process. Ensure good
ventilation and let the toaster complete a few cycles until no odour or smoke can be
noticed.
After a short cooling down period, your toaster will be ready for use. The operation instructions
are detailed below.
3. OPERATION
1. Plug the toaster into a power supply and introduce the bread loaves in the toaster's slots.
2. Turn the intensity level knob to the desired position.
3. Lower the lever, the toaster will start operating and the Stop button light will turn on.
4. The toaster will eject the bread loaves and will turn automatically off when it has finished
toasting.
5. Use the extra-lift system to remove the smallest bread pieces.
Reheat function
- Use this function to reheat cold toast.
- Introduce the toast in the toaster and lower the lever. Press the reheat button to select
this function.
Defrost function
Introduce the toast in the toaster and lower the lever. Press the defrost button to select this
function.
Stop function
To stop the toasting process at any time, press STOP.
Crumb tray
- The tray is designed to collect the breadcrumbs at the bottom of the device during the
toasting process.
- Press on the crumb tray to unlock it and to take it out.
- Empty it and then put it back in its position.
36
TOAST&TASTE DOUBLE W | TOAST&TASTE DOUBLE B