Publicidad
Idiomas disponibles
Idiomas disponibles
Power On & Settings
WARNING
To reduce the risk of injury from moving parts while the vacuum is turned on, always
move the vacuum via the rolling wheels by using the upper handle at the back of the
vacuum. Do not carry the vacuum while it is running. Always place vacuum on floor with
handle in upright position when using tools.
1
Press the red power button with your
foot to turn the vacuum ON
and
once again to turn your vacuum OFF
3
TIP: For optimal carpet cleaning performance, adjust to the lowest practical setting. If
your vacuum is difficult to push, adjust to the next higher setting.
NOTE: Rotating floor brush continues to rotate while tools are in use. Never place fingers
under the vacuum when it is running. Never place Powerfoot on furniture or uneven
surfaces. Do not place vacuum close enough to objects to pull into rotating brush.
NOTE: Certain carpets and low humidity conditions may generate small static
discharges. Static discharges are harmless and are not associated in any way with the
main power supply.
6
www.BISSELL.com
2
Press the Recline Pedal and pull handle
.
back towards you.
Turn the dial on the foot of the vacuum to the
desired setting. If the dial is difficult to turn, tilt the
vacuum back slightly to take the weight off the foot
while turning.
Lowest setting –
For low pile carpet or bare floors.
To pick up debris, it may be
necessary to move up one setting.
Medium setting – For medium pile carpet.
Highest setting – For high pile and most shag carpet.
Empty the Dirt Tank
WARNING
To reduce the risk of electric shock, turn power switch OFF and disconnect polarized plug
from electrical outlet before performing maintenance or troubleshooting checks.
1
Empty once tank is full.
3
Hold the Dirt Tank over a trash container.
Press the bottom release button to
empty. Once empty, close the lid.
5
Clean Cyclone with warm water and mild
detergent. Let Cyclone dry completely
before replacing. To replace, fit into place
and twist to the right.
NOTE: The Dirt Tank may be washed in warm water with a mild detergent. Make sure it
is completely dry before replacing.
2
Press the tank release button and pull
out to remove Dirt Tank.
4
Twist Cyclone left and pull down to
remove from tank.
6
click
After emptied,
place tank back
on vacuum and
press firmly until
you hear "click."
www.BISSELL.com
7
Publicidad
