Publicidad
Idiomas disponibles
Idiomas disponibles
Clean the Pre-Motor Filter
WARNING
To reduce the risk of electric shock, turn power switch OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
WARNING
Do not operate vacuum with damp or wet filters or without all filters in place.
1
Press the Tank Release Button and pull
out to remove Dirt Tank.
3
Allow filter to air dry completely before
placing back into the tank lid. The Carbon
Filter should be on top of the Foam Filter.
Maintain the TurboEraser ® Tool
1
2
Twist gray collar
Remove Brush Roll,
counter-clockwise,
Belt, and Paddle
until slot appears,
Wheel. Inspect
then separate
for damages and
faceplate.
replace if necessary.
8
www.BISSELL.com
2
Remove Carbon and Foam Filter from lid.
Hand wash in warm water and rinse well;
mild detergent may be used if desired.
4
click
Return tank back
on vacuum and
press firmly until
you hear "click."
3
To reassemble, align two clips on each
end of Paddle Wheel with Belt on
and pop back into place. Place Brush
Roll with belt back in. Faceplate will
not close properly if all parts are not
aligned correctly.
Replace Brush & Belt
WARNING
To reduce the risk of electric shock, turn power switch OFF and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
1
Unplug vacuum, turn over and unscrew
six (6) Philips-head screws to remove
the bottom cover. Lift brush straight out.
3
Belt
End Cap
Replace the Brush Roll and Belt by looping the Belt over the motor shaft and the
Brush Roll. Line up the end caps and pull the brush forward into place. This will
stretch the belt. Return bottom cover back on and replace the screws.
Clearing a Clog
1
2
Remove the Stretch
Check the Foot Hose on
Hose from the back
the back of your vacuum
of the vacuum by
down towards the bottom.
twisting it to the left.
If necessary, remove the
Remove any debris
screw from the Foot Hose
that may have gotten
and check for clogs.
clogged.
2
Clean debris from Brush Roll. Inspect by
placing on its end and spin. The Brush
Roll should spin freely, multiple times by
one flick. If it doesn't, replace Brush Roll.
Check belt for wear or cuts and replace
if necessary.
3
Check the air passageway on
the bottom of your vacuum.
Remove the bottom cover and
the brush. Remove any debris.
www.BISSELL.com
9
Publicidad
