Publicidad
21. This seat unit is not suitable for children under 6 months.
22. Do not fold the stroller and do not adjust the positions of the backrest while the child is in it!
23. ALWAYS engage the brake/parking device, while you do not hold the stroller or leave it even for a while.
24. When the pram body is installed on the stroller, please do not disengage the folding mechanism.
25. Do not use the stroller on stairs or the pavement. This may affect the strength of the construction and the
assembly.
26. The car seat does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a
suitable pram body, cot or bed.
27. Only spare parts which are supplied or recommended by the manufacturer/distributor shall be used.
28. The assembly, folding and unfolding of the stroller must be performed by an adult only.
29. The bumper bar should always be attached to the frame of the stroller while the child is in the stroller! Do
not lift the stroller by its board, it is dangerous for the child!
30. Do not allow the child to stand up in the stroller, climb or hand from it!
31. Do not allow children to play with the stroller! It is dangerous for children or animals to play or run close to
the stroller or under it!
32. Do not use the stroller on stairs or escalators, because you may lose control of the product, the child might
fall and get hurt! You should pay extra attention while ascending or descending the pavement or a step.
33. WARNING! KEEP FROM FIRE. Do not use the product close to direct sources of heat – heating devices,
cookers or open fire.
34. Avoid using the product close to water bodies (pools, etc.)!
35. Do not use on uneven terrains, gravel surfaces or grassy areas (on meadows or lawns), muddy areas.
36. After unpacking of the product, remove all packing materials. They are not a toy, do not allow your children
to play with them.
37. The handle of the stroller is for guiding the direction, not for pushing and loading the stroller on sidewalks
and stairs.
38.Use the basket for a child that cannot sit without someone`s help, to roll and stand up on its own, using
your hands and knee support! Maximum weight of the child: 9 kg.
PARTS AND POSSIBLE POSITIONS OF THE SEAT
SEE FIGURES PD-A and PD-B:
PD-A: 1. Frame and cot; 2. Carrycot; 3. Front wheels; 4. Rare wheels; 5.Armrest; 6. Canopy
ASSEMBLY STEPS AND USE
1.UNFOLDING THE STROLLER FRAME – ILLUSTRATION A: Unhook the folding mechanism, lift the handle until the tube
locks in place, you should hear a clicking sound.
2.INSTALLING THE FRONT WHEELS – ILLUSTRATION B: Insert the front wheel in the respective opening in the stroller
housing. Make sure that the front wheels are securely attached. Press the mechanism for fastening of the front wheel
down in order to fix a one-way direction lift it up for the wheels to move freely.
3.INSTALLING THE REAR WHEELS – ILLUSTRATION C: Lift the rear part of the frame and insert the rear wheels on the
axle; make sure that they click in place and are attached securely. Step on the rear side of the brake in order to stop, in
order to release the brake, step on the front side.
4. INSTALLING THE ARMREST – ILLUSTRATION D: Place the bumper bar in the plastic housing and make sure it is fixed.
The red button must pop out of the opening intended for it. In order to release it, press the red button of the bumper bar.
5.INSTALLING THE CARRYCOT – ILLUSTRATION E: Place the seat on the installation points on each side of the body. Press
down, until the buttons pop out of the openings in the seat intended for that purpose. Press the round button in order to
adjust the angle of the seat. Afterwards fasten with the tab.
6.USING THE SAFETY BELTS – ILLUSTRATION F: Insert both side connectors of the buckle, you should hear a clicking
sound, when they are correctly engaged. The shoulder belts are placed by connecting and inserting the metal connectors
in the buckle.The sliding adjusters are placed and must be carefully adjusted on each side, so that the belt is tight around
the child without causing discomfort. Press the button of the buckle, pull, in order to open it.
7.INSTALLATION AND OPERATION WITH THE CANOPY – ILLUSTRATION G: Installation of the canopy : Attach the canopy
to the upper part of the frame. Pull the zip.
Operation with the canopy: Pull the canopy forwards, in order to unfold it and backwards – in order to fold it.
8. ADJUSTING THE BACKREST OF THE CARRYCOT – ILLUSTRATION H: There are 3 safety buckles at the back of the
stroller. In order to switch to sitting mode – engage the three buckles. In order to switch to lying mode – disengage the
three buckles. 1. Upper buckle; 2. Middle buckle; 3. Lower buckle.
16
Publicidad
