Connection Of An External Video Source; Initial Startup; Activating The Remote Control - Blaupunkt TV Tuner 04 Instrucciones De Manejo

Installation and connection
Connection of an external
video source
You can also connect an external audio/video
source (e.g. DVP/MVP) to the TV tuner. To
be able to remotely control the video source
as usual with the CCA or CCU, you must use
the video remote cable (7 607 006 437)
for the connection.
Connect the video remote cable with the
Audio L/R outputs and the 6-pole Molex
socket at the video device and connect it to
the A/V Input – Audio/Remote socket E
of the TV tuner.
The video connection to the TV tuner re-
quires the video cable (7 607 263 001).
Connect the video cable with the video
output of the playback device and with
the A/V Input – Video input F of the
TV tuner.
18

Initial Startup

When you operate the TV tuner for the fi rst
time, you must insert the batteries in the
remote control.

Activating the remote control

Inserting the batteries
The IR remote control requires two 1.5-V
AAA batteries for operation which are part
of the scope of delivery.
u
Open the battery compartment at the
back of the remote control.
u
Insert the batteries (as depicted in the
battery compartment).
u
Close the battery compartment.
Using the remote control
Point the remote control at the separate
infrared receiver J.
Operating angle: Approximately 30° in
each direction from the front of the remote
control.
Initial Startup