Tesmed Absolute Manual De Instrucciones página 43

TROUBLESHOOTING GUIDE
Problems
The display does not
switch on
The display works but
the belt does not provide
stimulation
Contractions are very
weak, even when the
intensity is high, and you
feel discomfort
An acoustic signal is
heard, and a message
appears on the display to
check contact between
the belt and the skin.
Problems other than
those listed above
Possible Causes
Low battery
The intensity level
may be too low
Possibly dry
electrodes and skin
The control device is
not correctly
positioned on the belt
Possibly dry
electrodes and skin
The belt is not properly in
contact with the skin.
The belt or part of the belt
is probably defective
43
Solutions
Charge the battery
Press the + button to
increase intensity.
Ensure that you are
increasing the intensity of
the channel in use
Wet both the electrodes
and the skin
Make sure that the con-
trol device and the belt
are correctly
connected via magnets
Wet both the electrodes
and the skin
Tighten the belt to
increase contact with the
skin.
Contact TESMED
Support
info@tesmed.com