Kreg Pro Serie Manual Del Propietário página 8

Swing Stops
Two swing stops assist in drilling pocket holes in the same location
on multiple work pieces. When not used, the swing stop pivots out of
the way, allowing the work piece to slide underneath and rest against
the fence. To change swing-stop location, loosen the knob, move the
stop to the new location and tighten the knob.
Air-System Filter
The air-system filter maintains a clean, moisture-free supply of
compressed air to the machine and periodically must be drained.
(1) Push the drain valve up toward the reservoir or to the side.
(2) Let system air pressure blow out the collected fluid.
(3) Release the drain valve.
WARNING:
Before removing the filter reservoir to clean or replace the filter,
disconnect the machine from the air supply. Cycle the machine via the foot switch several times
to remove air from the system.
Air-System Lubricator
The air-system lubricator is filled with air-motor oil and maintains
proper pneumatic motor lubrication. The lubricator is factory set
at ½ turn open. The oil level should be routinely checked and refilled
with air motor oil comparable to that provided. Normal use of the
machine causes a light oil film to accumulate on the underside
of the top plate where the pneumatic motor exhausts.
WARNING:
Before filling the lubricator, disconnect the machine from the air supply.
Cycle the machine via the foot switch several times to remove air from the system.
DK5100
Drain
Knob
Swing Stop
Lubricator
Fill Cap