Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING: You cannot use PC and YPbPr at the same time.
5.
S/PDIF Coaxial Out
outputs digital audio signals of the currently watched source.
Use an SPDIF coaxial cable to trasfer audio signals to a device that has S/PDIF input
Viewing the Connections - Side Connectors
1.
CI Slot is used for inserting a CI card. A CI card allows you to view all the channels
that you subscribe to. For more information, see "Conditional Access" section.
2.
USB Input.
Note that programme recording feature is available via the USB input. You can
connect external hard disk drives to this input.
3.
Video Input is used for connecting video signals of external devices.Connect the
video cable between the VIDEO IN socket on the TV and the VIDEO OUT jack on
your device.
4.
Audio Inputs are used for connecting audio signals of external devices. Connect
the audio cable between the AUDIO INPUTS on the TV and the AUDIO OUTPUT
jacks on your device. Note: If you connect a device to the TV via the VIDEO
INPUT, you should also connect your device with an audio cable to the AUDIO
INPUTS of the TV to enable audio. .
5.
Component Video Input (YPbPr)
You can connect the component video and audio sockets with a device that
has component output. To do this, you must use the supplied component video
connection cable for enabling connection. First, plug single jack of the cable to
the TV's YPbPr socket (side). Afterwards, insert your component cable's (not
supplied) connectors into the plural part of the Component video connection cable.
Colours of the connected jacks should match.
6.
Headphone jack is used for connecting an external headphone to the system.
Connect to the HEADPHONE jack to listen to the TV from headphones (optional).
Power Connection
IMPORTANT: The TV set is designed to operate on 220-240V AC, 50 Hz.
•
After unpacking, allow the TV set to reach the ambient room temperature before you connect the set to the
mains. Plug the power cable to the mains socket outlet.
Aerial Connection
•
Connect the aerial ,cable TV plug to the AERIAL INPUT socket located at the rear of the TV.
is used for connecting component video.
English - 43 -
Publicidad
