Publicidad
Idiomas disponibles
Idiomas disponibles
king with electrical devices the following prevention and safety instructions are to be observed to
avoid fires, electric shocks and physical injuries!
Inserting the Saw Blade
1. Remove the mains plug from the socket and ensure that the on and off switch is not locked with
the locking button.
2. Push up the transparent eye protection,
3. Loosen the hexagon screws on the saw blade-fixing device with the offset hexagon bar key
supplied, and push the saw blade as far as possible into the fixing device. Ensure that the teeth of
the saw blade are pointing to the front!
4. Slightly tighten the hexagon screws alternately in order to position the saw blade. Then turn, the
screws until they are completely tight.
5. Push the transparent eye protection down again. The spanner can be pushed into the holder for
safekeeping.
Adjusting the Guide Roller
For greater accuracy during sawing, the device 4 is fitted with a guide roller. This roller should be
adjusted in such a way that it touches the back edge of the saw blade during cutting.
• Ensure that the on and off switch is not pressed or locked in place and that the mains plug is not
inserted in the socket!
• Loosen the hexagon screws of the shoe of the saw.
• Push the guide roller forwards until It touches the back edge of the saw blade.
• Tighten the hexagon screws again.
NOTE: If the guide roller axle is oiled occasionally, thie will extend the working life of the guide roller!
One drop of resin-free oil is sufficient!
Initial Operation
1. Ensure that the on and off switch is not pressed or locked in place with the locking button. that
the saw blade is fitted tightly in the saw btade fixing device and that the hexagon screws of the shoe
of the saw are tight! Push down the transparent eye protection.
2. Insert the mains plug into a correctly installed 230volt, 50-hertz socket.
3. Bring the saw up to the object to be cut.
4. Press the on and off switch In order to switch on the machine. For continuous operation the on
and off switch can be locked in place with the locking button. In order to release this, press the on
and off switch as far as possible and then let it go. The locking button will automatically jump back
to the original position.
5. After use the mains plug should be removed from the socket.
NOTE: Do not cut directly into the workpiece with the saw blade, but first drill a corresponding hole
from which to start cutting!
Adjustment for the Bevel Cut
The shoe of the saw can be adjusted as follows on both sides up to an angle of 45°:
1. Remove the mains plug from the socket and ensure that the on and off switch is not locked in
place with the locking button.
2. Loosen (but do not remove) the hexagon screws of the shoe of the saw with the offset hexagon
key provided.
3. Pull the shoe of the saw back slightly and adjust the desired angle according to the scale on the
shoe.
5
Publicidad
