Cameo ZENIT B200 Manual De Usuario página 11

COLOUR TEMPERATURE (Tunable White)
The colour temperature mode enables you to configure the colour temperature from cold white to warm white (CTC) and the brightness (Dim) of the
light directly on the device. Select the colour temperature mode as per the procedure previously described in SETTING STAND ALONE MODE and
confirm with ENTER. Using the UP and DOWN controls, now select the menu item that you wish to edit (observe arrow) and confirm with ENTER.
The display will show a three-digit number field and you can use the UP and DOWN controls to configure the desired value. Confirm with ENTER.
Press MODE three times to return to the main display (Mode Tunable White).
----------- Stand Alone -----------
Auto
Colour Macro
Static
Tunable White
User Colour
Timer
USER PRESETS (User colour)
The operating mode "User Presets" allows you to store five individual colour presets of overall brightness, strobe and a colour mix of R, G, B and W
directly in the device. Select the "User Colour" mode as per the procedure previously described in SETTING STAND ALONE MODE and confirm with
ENTER. Use UP AND DOWN to select one of the stored presets Color1 to Color5 and confirm with ENTER and select the submenu item you want to
edit (see arrows). Confirm with ENTER.
The display will show a three-digit number field and you can use the UP and DOWN controls to set the value as required between 000 and 255.
Confirm by pressing ENTER again. When all settings are configured as required, press MODE 4 times to return to the main display (Mode User
Colour).
----------- Stand Alone -----------
Auto
Colour Macro
Static
Tunable White
User Colour
Timer
TIMER FUNCTION (Timer)
The timer function allows the standalone modes "Colour Macro", "Static", "Tunable White" and "User Colour" to be timer controlled in such
a way that the fade-in time can be set from 0 to 60 minutes, the dwell time from 1 to 24 hours and the fade-out time from 0 to 60 minutes.
Time control starts immediately after activating the timer function in the previously activated standalone mode and remains active even
if the spotlight is switched off and restarted. Select "Timer" by means of the procedure described above under CONFIGURE STANDALONE
MODE and confirm with ENTER. Now select "Fade In", "Dwell Time" or "Fade Out" for the individual settings (observe arrow) and confirm
with ENTER. The display will show a three-digit number field in each case. Use UP and DOWN to set the value as required from 000 to 060
or 001 to 024. Confirm by pressing ENTER again. Once all settings have been configured as required, activate the timer function by selecting
the submenu item "Timer On/Off" using UP and DOWN, confirm with ENTER, select "On" and confirm again with ENTER (to deactivate the
timer function, please select "Off" and confirm). Press MODE three times to return to the main display.
----------- Stand Alone -----------
Auto
Color Macro
Static
Tunable White
User Color
Timer
Please note: The timer function is suitable for use in master/slave mode via cable and W-DMX™.
---------- Programme x ----------
Dim <100>
CTC <255>
Dim CTC
000 000
– –
100 255
------------ User Colour ------------
Color1
Color2
Color3
Color4
Color5
------------ Timer ------------
Timer On/Off
Fade In < 1min >
Dwell Time < 1h >
Fade Out < 1min >
Mode
Tunable White
------------ Colour1 ------------ 001
Dimmer <255>
Strobe <255>
Red <255> 255
Green <255>
Blue <255>
White <255>
–
Mode
User Colour
11