stayer FH700 Manual De Instrucciones página 18

gb
When working stone, use dust extraction. The
vacuum cleaner must be approved for the extraction of
stone dust. Using this equipment reduces dust related
hazards.
Use a cutting guide when cutting stone. Without
sideward guidance, the cutting disc can jam and cause
kickback.
When working with the machine, always hold it
firmly with both hands and provide for a secure
stance. The power tool is guided more secure with
both hands.
Keep your workplace clean. Blends of materials are
particularly dangerous. Dust from light alloys can burn
or explode.
Never use the machine with a damaged cable. Do
not touch the damaged cable and pull the mains plug
when the cable is damaged while working. Damaged
cables increase the risk of an electric shock.
2_FUNCTIONAL DESCRIPTION
Read
instructions. Failure to follow the warnings
and instructions may result in electric
shock, fire and/or serious injury.
Secure the workpiece. A workpiece clamped with
clamping devices or in a vice is held more secure than
by hand.
2.1. INTENDED USE
The machine is intended for cutting, roughing, and
brushing metal and stone materials without using
water.
With approved sanding tools, the machine can be
used for sanding with sanding discs.
2.2. PRODUCT FEATURES
The numbering of the product features refers to the
illustration of the machine on the graphics page.
1 Release screw for protection guard
2 Spindle lock button
3 On/Off switch
4 Auxiliary handle
5 Grinder spindle
6 Protection guard for sanding
7 Mounting flange
8 Grinding/cutting disc
9 Clamping nut
10 Lock switch (SAB900RPS)
11 Long switch (SAB900RPS)
all safety warnings
2.3. NOISE/VIBRATION INFORMATION
The values given are valid for nominal voltages
[U] 230/240 V ~ 50/60 Hz - 110/120 V ~ 60Hz. For
lower voltage and models for specific countries, these
values can vary. Please observe the article number on
the type plate of your machine. The trade names of the
individual machines may vary.
We reserve the right to change related to technical
advance.
= Rated input power
W
= Nº of revolutions without load
rpm
= Maximum disk diameter
Ø
= Spindle thread
= Mass
and all
Typical noise levels in evaluation A:
= Acceleration typically evaluated in the hand/
arm
LPA = Acoustic pressure level
LWA = Acoustic power level
The noise level when working can exceed 85 dB (A).
Wear helmets hearing protection!
Measured values established in accordance with
EN 60745.
The technical specifications set forth herein are
understood within certain tolerances (In accordance
with the present arrangements).
2.4. DECLARATION OF CONFORMITY
We declare under our sole responsibility that the product
described under "Technical Data" is in conformity with
the following standards or standardization documents:
EN 60745-1, EN 60745-2-3, EN 55014-1, EN 55014-
2, EN 61000-3-2, EN 61000-3-3 according to the
provisions of the directives 2006/42/CE, 2014/30/
EU,2011/65/EU.
Ramiro de la Fuente
Director General
January 2019
- 18 -