Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING & WARRANTY
TROUBLE
Improper loading
Too little rinse-aid
Dishes are removed too soon.
The dishes are
not drying
Wrong program selection
Using cutlery with a
low-quality coating
ERROR CODES
When some malfunctions come on, the appliance will display error codes to warn
you:
CODES
E1
Longer inlet time.
Not reaching required
E3
temperature.
E4
Overflow.
Failure of communication
Ed
between main PCB with TFT
PCB
WARNING: If overflow occurs, turn off the main water supply before calling for
service.
If there is water in the base pan because of an overfill or small leak, the
water should be removed before restarting the dishwasher.
POSSIBLE CAUSE
MEANINGS
POSSIBLE REMEDY
Load the dishwasher as suggested in the
directions.
Increase the amount of rinse-aid/Refill the
rinse-aid dispenser.
Do not empty your dishwasher immediately
after washing. Open the door slightly so
that the steam can escape. Begin unloading
the dishwasher only once the dishes are
barely warm to the touch. Empty the low
basket first. This prevents water from
dropping off dishes in the upper basket.
In short program the washing temperature
is lower. This also lowers cleaning
performance. Choose a program with a
long washing time.
Water drainage is more difficult with these
items. Cutlery or dishes of this type are not
suitable for washing in the dishwasher.
POSSIBLE CAUSE
Faucets is not opened, or water intake is
restricted, or water pressure is too low.
Malfunction of heating element.
Some element of dishwasher leaks.
Open circuit or break of wiring for the
communication.
ENGLISH
Page 29
Publicidad
