Publicidad
Idiomas disponibles
Idiomas disponibles
Very carefully check the spacing between all the posts (side S in chapter 8.1) and that they are positioned vertically.
The levels between each of them must also be checked.
After alignment completion, ensure that the diagonals are equal.
Once the wedging is completed, fill the trenches with a bit of sand.
10. Assembling the bottom rails
If the pool is not installed on a concrete slab, place a concrete slab of around 30 x 30 x 5 cm at each connecting point of the
bottom rails (rounded parts of the pool). These slabs must be placed in such a way that their surface arrives exactly at ground
level.
WARNING: The connecting plate must lie totally flat against the entire length of the concrete slab. The absence of a
concrete slab or using one that is too short may result in an inadequate installation and could lead to the collapse of the
pool.
Before assembling the bottom rails of the rounded parts of the pool, place the metal sheet wall inside the enclosure of the pool.
1212 or 1615 or 1618
Metal rail
Sand
11. Installation of the pool wall
WARNING: An incorrectly installed metal sheet could cause the pool to collapse. Do not install the metal sheet in windy
weather.
NOTE: For some larger sized pool models, the wall is composed of two half-walls in order to facilitate handling (for some
models, the weight of the wall may exceed 100 kg). This does not change the way in which the wall is installed.
Use the ladder to enter and exit the pool during installation. Take the pool wall out of
the box and place it on top of the box or on a board for easy unravelling.
Ensure that the skimmer cut out is placed on the top part of the metal sheet, with
the opening positioned facing the prevailing wind, so that the wind blows any
impurities towards the skimmer.
We recommend installing the metal sheet wall so that the skimmer and discharge
nozzle cut outs are located on a rounded side of the pool and not on a straight side of
the pool. Begin by pushing the metal sheet into the groove of the profiles and continue
until the wall is completely unrolled.
VARUNA-SAPHIR-CANYON Oval
YES
Sand
Slab 30 x 30 x 5
cm
107
NO
Liner
2268
Connecting plate
In the rounded parts, slide the rails
into the connecting plates leaving
Support leg
a space of around 1 cm between
assembled
the rails in the centre of the
connecting plate.
Skimmer cut outs and
discharge nozzle
Pool interior
Pool exterior
Guide 880110-rev F
Publicidad
