VONROC AF501AC Traducción Del Manual Original página 7

• Speed button (5): push to cycle between high,
medium or low fan speed. The display will show
the speedsetting: 1 slow, 2 medium and 3 high.
• Oscillation button (2): Press the oscillation
button to activate the heater to swing. The light
below the button will light up when the oscilla-
tion is active. Press it again to deactivate. Don't
force to swing the fan head by hand, or it will be
damaged permanently.
• Mode button (4): Press the mode button to
change between 3 modes 'Natural Wind', Sleep-
ing wind' and 'Ordinary wind'.
• Timer button (1): Press this key when power is
on, timer increases one hour by one pressing,
time of timer varies with different models. And
the product turns off automatically when time
is up. By pressing this key continuously until it
displays '00', the timer will be canceled.
• All indication lights on the screen lights out
after 3 minutes without operations. Screen
awakes when press any key.
Function of the remote control (Fig. C)
• Push the "ON/OFF" button (3) to working state,
push it again to turn it off.
• Speed button (5): push to cycle between high,
medium or low fan speed. The display will show
the speedsetting: 1 slow, 2 medium and 3 high.
• Oscillation button (2): Press the oscillation
button to activate the heater to swing. The light
below the button will light up when the oscilla-
tion is active. Press it again to deactivate. Don't
force to swing the fan head by hand, or it will be
damaged permanently.
• Mode button (4): Press the mode button to
change between 3 modes 'Natural Wind', Sleep-
ing wind' and 'Ordinary wind'.
• Timer button (1): Press this key when power is
on, timer increases one hour by one pressing,
time of timer varies with different models. And
the product turns off automatically when time
is up. By pressing this key continuously until it
displays '00', the timer will be canceled.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
mains plug from the mains.
WWW.VONROC.COM
Always remove the plug from the socket
when the device is not being used.
Clean with neutral detergent and soft cloth.
TROUBLESHOOTING
In case the tower fan does not work well, we give
you subjoined some possible causes and their
solutions.
Problem Possible cause Treatment
The tower fan does
The plug is loose,
not operate, even
bad connection.
when it is plugged
in and the switch
is turned on.
No power in
socket outlet.
The appliance
Abnormal noise. is not standing
upright.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EU
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of
defects in both materials and workmanship for the
period lawfully stipulated starting from the date of
original purchase. Should the product develop any
failure during this period due to defective material
and/or workmanship then contact VONROC directly.
EN
Pull out the
plug, check the
connection of the
plug and socket.
Then connect
again.
Insert the plug in
a proper socket.
Put the tower fan
on a level surface.
7