Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING! The cutting head continues to
rotate after the edger has been switched off;
wait until it has completely stopped then lay down
the tool.
For Battery tools
The recommended ambient temperature range for
discharging is -4°F~113°F (-20 ~45 ).
The recommended ambient temperature range for
the charging system during charging is 23°F~113°F
(-5 ~45 ).
TRANSPORTATION
Transporting the edger
1. Switch off the edger and remove the battery.
2. When transporting your edger by hand, hold the
middle of shaft to make sure that your machine is
parallel to the ground.
3. When transporting your edger in a vehicle, secure
and position it to prevent movement or damage.
Transporting the battery
1. Ensure the battery is in a safe condition.
2. Use non-conductive packaging when
transporting the battery.
3. The contained Li-Ion batteries are subject to the
dangerous goods legislation requirements.
EN
Transport batteries only when the battery
housing is undamaged. Pack up the batteries in
such a manner that cannot move around in the
packaging.
MAINTENENCE
Replacing the blade (See Fig. F1,F2,F3)
F1
10
F2
1
F3
2
1
1. Align hole in inner blade adapter with notch in
gear housing, and insert locking tool to prevent
from rotating.
2. Loosen the bolt.
3. Replace the blade and tighten the bolt to 15~20
Nm (11~15 ft-lb).
Lubricating the Gear Box (See Fig. G1, G2)
G1
2
1
2
Publicidad
