Publicidad
Idiomas disponibles
Idiomas disponibles
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the
equipment and receiver.
- Connect the equipment into an outlet on a
circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV
technician for help.
SYMBOLS
To reduce the risk of injury,
user must read instruction
manual
Wear ear protection
Li-Ion battery, battery must be
recycled
Do not burn
Batteries may enter water
cycle if disposed improperly,
which can be hazardous for
ecosystem. Do not dispose of
waste batteries as unsorted
municipal waste.
Wear protective gloves
Remove battery from the
socket before carrying out
any adjustment, servicing or
maintenance.
POSITEC Inc. has established a partnership
with the RBRC Corporation to recycle any
Positec batteries with the RBRC-call2recycle
seal. For environmental protection, please do
not discard batteries in the trash. After the
batteries' life cycle is ended, then please call
1-800-822-8837 for a free service that will
properly dispose of the battery.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
BEFORE OPERATION:
Assembling the Front Handle (See Fig. A1,
A2)
A1
A2
1. Remove the tape.
2. Attach the Front Handle and lower clamp on the
shaft.
3. Put the bolt through the holes.
4. Tighten the Front Handle.
WARNING: Adjust the Front Handle as
desired so as to make sure your front arm is
straight when using the edger.
Fitting the shoulder strap (Sold Seperately)
(See Fig. B1)
1. Adjust the length of shoulder strap to make sure
that the carabiner is about a hand's width below
the top of your hip.
2. Connect the carabiner of shoulder strap to the
Shoulder Strap Mount on the shaft of the edger.
EN
7
Publicidad
