Avanti WDTZ000 Manual De Instrucciones página 10

You can solve many common water dispenser problems easily, saving you the cost of a
possible service call. Try the suggestions outlined below to see if you can solve the problem
before calling the servicer.
PROBLEM
Water dispenser does not operate.
Water cooler is not cold enough.
Water dispenser hot water is not hot enough.
Compressor turns on and off frequently.
Vibrations.
The water dispenser seems to make too much
noise.
Bottle feels warm.
Water bottle is hot.
PROBLEMS WITH YOUR WATER DISPENSER?
TROUBLESHOOTING GUIDE
POSSIBLE CAUSE
Not plugged in.
The circuit breaker tripped or a blown fuse.
Check to be sure the cold switch on the back is ON.
The water dispenser does not have the correct
clearances.
Check to be sure the hot switch on the back is ON.
The room temperature is hotter than normal.
The temperature control is not set correctly.
The water dispenser does not have the correct
clearances.
Check to assure that the water dispenser is level.
The rattling noise may come from the flow of the
refrigerant, which is normal.
As each cycle ends, you may hear gurgling sounds
caused by the flow of refrigerant in your water dispenser.
Contraction and expansion of the inside walls may
cause popping and crackling noises.
The water dispenser is not level.
The water system is overfilled. Dispense Cold water until
air is released into the bottle.
Water is boiling in the hot tank and bubbling up into the
bottle. Press the hot dispenser button until water flows to
remove air from the hot tank.
10