TROUBLESHOOTING
WARNING: Turn off the tool and detach the battery pack from the tool before performing
troubleshooting procedures.
PROBLEM
Workpiece contact element does not
depress fully - tool does not operate.
Tool operates properly, but the nails are
not fully driven into the workpiece.
Tool operates properly, but the nails are
driven too deep into the workpiece.
Tool jams frequently.
Tool will not drive a fastener or cycles
without driving a nail
WARRANTY
For 5 years from the date of purchase, the power tool is warranted and for 3 years from date of
purchase the battery & charger are warranted for the original purchaser to be free from defects
in material and workmanship. This guarantee does not cover damage due to abuse, normal
wear, improper maintenance, neglect, unauthorized repair/alteration, or expendable parts and
accessories expected to become unusable after a reasonable period of use.
If you think your product meets the above guarantee criteria, but the nailer doesn't shoot nails
any more or the workpiece contact/magazine doesn't work after being used for a period of
time, please return it to the place of purchase with valid proof of purchase and the defective
product will be repaired or replaced at no charge. This guarantee gives you specific legal
rights, and you may also have other rights that vary from state to state.
POSSIBLE CAUSE
Too few nails in the
magazine.
Workpiece contact
element is jammed.
Depth of drive isn't deep
enough.
Nail is too long for wood
hardness.
Depth of drive is too
deep.
Incorrect nails.
Damaged nails.
Dirty magazine.
Driving mechanism is
dirty.
16
CORRECTIVE
ACTION
Reload the magazine
with nails.
Remove the battery pack
and clear debris.
Adjust the depth of drive;
Use the nail length that
is appropriate for the
wood type.
Adjust the depth of drive.
Verify that the nails are
the correct size.
Replace nails.
Clean the magazine.
Clean the nail channel
as described in the
Maintenance section of
the manual.
Lowe's Home Centers LLC.
MOORESVILLE, NC 28117
Printed in China