Candy CCBS 6182XH Guía Rápida De Uso página 13

2 If present, install the wall spacer in a central position at the rear
of the appliance.(Fig.2)
3 Adjust the feet to ensure the stability of the appliance and prevent
vibrations and noise (fi g. 3). If the front part is higher than the rear,
the door can be closed more easily.
NOTE:
If your refrigerator is in stainless steel or other special fi nish, it might
come with a peel-off coating that protects the surface.
To remove this protection, do not use sharp objects that could damage it.
Electrical connection
After shipping, place the appliance vertically and wait at least 2 - 3 hours
before connecting it to the electrical system. Before inserting the plug
into the electrical socket, make sure that:
• The socket is earthed and in compliance with the law.
• The socket can withstand the maximum power load of the appliance,
as indicated on the nameplate of the refrigerator.
• The power supply voltage is within the amounts indicated on the
nameplate of the refrigerator.
• The socket is compatible with the plug of the appliance. If not, request
replacement of the plug by an authorized technician; do not use extension
cords and/or multiple connectors.
• When the appliance is installed, the electrical cord and the current
socket must be easily reached.
• The cord must not be folded or compressed.
• The cord must be checked regularly and replaced solely by authorized
technicians.
• The manufacturer declines any liability whenever these safety measures
are not respected.
Appliance start-up
Remove all wrapping/packaging present inside the appliance and clean
with water and baking soda or neutral soap.
After the installation, wait 2 - 3 hours to allow time for the refrigerator/
freezer to stabilize at normal working temperature, before placing fresh
or frozen foods inside.
If the power cord becomes disconnected, wait at least fi ve minutes
before restarting the refrigerator/ freezer. At this point, the appliance is
ready for use.
Turning On/Off
• The thermostat unit for control of the appliance is located inside of the
refrigerator compartment (Fig.4).
Rotate the thermostat knob of the thermostat beyond the "0" position.
The light is on when the refrigerator door is open. Turning the knob to "0"
completely turns off the product.
Turning the knob to "0" completely turns off the product
Fig.2
Temperature adjustment
Fig.3
3
•The temperature adjustment of both compartments is effected by rotating
the thermostat knob (fi g. 5).
Select the desired position:
• For colder temperature in the refrigerator and in the freezer, by turning
towards MAX .
• For temperature less cold in the refrigerator and in the freezer, by
rotating in the direction of 0.
Refrigerator Compartment Fan
The fan is preset to OFF.
To activate, press the switch (fi g. 6)
To optimize energy consumption, it is recommended that you turn the fan
on only when the ambient air temperature exceeds 28 to 30°C.
EN 11
OPERATION
(no display)
(no display)
(if present)
Fig.4
Fig.5
Fig.6