TECNA 9310 Manual De Uso página 11

t
ranslation of the
WARNING: periodically (for example, once every work shift) check the condition of the ground cable, the tightness
of the marked screw
WARNING: check the grounding status on a regular basis (for example, once every work shift). Use a voltage
tester to make sure voltage runs between the redance at the bottom of the rope and the grounding cable con-
nection screw.
- check that the rope's movement is smooth and that it does not make any strange noises;
- do not lubricate the balancer with flammable or volatile fluids;
- do not remove any labels. Replace any damaged labels;
- the balancer must be inspected at least once a year by skilled, authorized personnel.
In case of unusual behaviour of the balancer, contact your dealer.
M
aintenance
ATTENTION: check the condition of the ground cable and the tightening of the screw
a regular basis (for instance, once after every work shift) and carefully remove dust so that it will not build-up,
i.e. not more than 5 mm.
ATTENTION: Check the grounding status on a regular basis (for example, once every work shift). Use a volta-
ge tester to make sure voltage runs between the redance at the bottom of the rope and the grounding cable
connection screw.
WARNING: periodically (for example, once every month) check and thoroughly clean all the balancer's parts.
WARNING: periodically (for example once every 6 months) check the condition of the external surfaces in order
to verify the absence of corrosion or dangerous damage.
ATTENTION: replace the drum every 100,000 (hundred thousand) cycles.
Maintenance may be carried out only by skilled and authorized personnel.
Use original TECNA S.p.A. spare parts only. When requesting spare parts, the Customer should kindly contact the supplier of the
balancer or the manufacturer directly, specifying the equipment's identification data printed on the plate.
Do not make any modification to the rope group and, specifically, DO NOT SHORTEN the rope: if needed, please get in touch with
the supplier or the manufacturer directly.
Never disassemble the balancer. Maintenance is to be carried out only by skilled, authorized
personnel.
W
arranty
The use of non-original TECNA S.p.A. spare parts will negatively affect safety and performance and, in any case, it will void the warranty.
The rope and the drum-spring are not covered by warranty.
D
isposal
At the end of the work life of the balancer, proceed as follows:
- Rewind the rope completely
- Unhook the load from the balancer
- Unhook the balancer from the primary and safety connections.
- Proceed to fully discharge the balancer spring.
Once the balancer has been discharged, it must be disposed of complying with the rules and regulations in force.
o i
riginal nstrUctions
(EN 13463-1:2009) and carefully remove dust, avoiding dust buildup greater than 5mm.
11
EN
(EN 13463-1:2009) on