Ryobi A90DS01 Guia De Inicio Rapido

DEBRIS SHIELD ATTACHMENT
A90DS01
For use with RYOBI FVM51, TVM01, RRT100, and RRT200
Rotary Tools.
WARNING!
To reduce the risk of injury, user must read and understand
the operator's manual for their rotary tool and this instruction
sheet. Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Ensure compatibility and fit
before using this accessory. Do not use this accessory if
a part is damaged or missing. If you are not comfortable
performing any of the functions described in these
instructions, take your unit to an authorized service center.
WARNING:
Never install, remove, or adjust any attachment head while
rotary tool is running. Failure to stop the motor can cause
serious personal injury. Never operate rotary tool without an
attachment head or the collar installed.
NOTE: Follow all guidelines and warnings in your rotary tool
operator's manual.
Use the debris shield attachment to redirect debris and sparks
generated when cutting, sanding, and grinding.
INSTALLING THE DEBRIS SHIELD ATTACHMENT
See Figures 1 - 3.
 Verify the rotary tool switch is in the OFF (O) position
and unplug the rotary tool or remove the battery pack, if
applicable.
 Engage the spindle lock and remove accessories and quick-
change collet according to the rotary tool operator's manual.
 Hold the collar firmly, then turn it counterclockwise to loosen
and remove.
 Slide the attachment head onto the threaded end of the tool.
 Hold the attachment head firmly, then turn it clockwise to
tighten and secure.
 Engage the spindle lock and install the quick-change collet
and accessory according to the rotary tool operator's manual.
Ensure collet and accessory are secure.
USING THE DEBRIS SHIELD ATTACHMENT
See Figure 4.
 Verify the rotary tool switch is in the OFF (O) position and
plug in the rotary tool or install the battery pack, if applicable.
 Select the appropriate speed according to the rotary tool
operator's manual and start the tool.
 Position the tool and/or debris shield attachment to provide
maximum protection during operation.
 Move the bit through the workpiece.
NOTE: Do not force. Use only enough pressure to keep the
bit moving. Let the bit and tool do the work.
 When finished, turn off the rotary tool.
Fig. 1
A
A - Collar (collier, collar)
Fig. 2
A
A - Attachment head (tête de l'accessoire, cabezal del accesorio)
Fig. 3
B
A - Quick-change collet (collet à changement rapide, portabroca de cambio
rápido)
B - Accessory (accessoire, accesorio)
Fig. 4
ONE WORLD TECHNOLOGIES, INC.
P.O. Box 1288, Anderson, SC 29622
Phone 1-800-525-2579 - www.ryobitools.com
A